Terske Narwheel LTS Thru Axle Wheel Holder | Truck & Van | L-Track 80/20 T-Track

Description

L
-track |
T
-track |
S
tud
The Narwheel LTS Thru Axle Wheel Holder was made to take advantage of the security and flexibility in van, truck, and trailer mounting systems to securely hold thru axle bicycle wheels while in transit.
The Narwheel LTS is CNC machined from 6061 aluminum and features a stepped stub axle and wingnut that will accommodate several sizes of front and/or rear hubs (see compatibility list below).
Two pairs of holes, each spaced 3in (76mm) on center, allow the use of either 3/8in (as commonly found on L-Track mounting studs) or 1/4in (T-track, 80/20 framing, or wall stud lag screw) hardware.
Please use your best judgement when mounting!  We can't control or evaluate the surface you choose to mount these to or the suitability of the hardware you select, so take care when mounting in vehicles or where a falling wheel might injure someone.
Compatibility
Front:
12 x 100mm (road standard) front hubs
15 x 100mm (mountain standard) front hubs
15 x 110mm (mountain Boost) front hubs
Rear:
12x142mm (XC/Road standard) rear hubs
12x148mm (Boost standard) rear hubs
15x150mm (
fatbike
)
front
hubs
12x157mm (Super Boost Plus) rear hubs
Mounting holes will accept 3/8in or 1/4in hardware. Mounting hardware and surface/anchor evaluation is the responsibility of the user.
Mounting hardware not included
For indoor use only.
Installation
Materials Required:
Blue threadlocker (Loctite 242 or equivalent)
17mm open-end wrench or torque wrench with 17mm crow's foot
Mounting hardware as appropriate
Mounting anchors as appropriate
Apply a drop of threadlocker to hex-end axle thread.
Hand-thread axle into base plate
Use 17mm wrench to torque axle to base plate with a force of 8-10Nm.
Mount to track or other vertical surface using appropriate hardware and anchors
Ceiling mounting is not recommended. Especially where the wheel or mount could fall and hurt someone.
Take care to ensure that there is enough space to mount your largest anticipated wheel/tire combination to the mount.
Slide wheel hub over axle and appropriate shoulder
Thread nut onto axle and hand-tighten to approximately 6-8 Nm (as tight as—but not tighter than—you'd install a thru axle).
Re-check axle tightness every month or whenever play develops and re-tighten as needed.